Alstom FKG1X - Page 135

Installation
Assembly of th
e circuit b
reaker on-
-
site
G31--201EN12
18/20
04--2011
© ALSTOM 2010. All rights reserved. Informat
ion contained in
this document is indicative only. No
representati
on or
warrant
y is
given or should
be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liabili
ty and
is subject to
change without notice. Reproduction, use or disclosure to
third parties, without express writt
en authority, is
strictly prohibited.
 GRID
Installing the circuit breaker – Step 4,
Cleaning inside
the enclosure
Before re-assembling the covers :
D
Check the cleanliness inside of the enclosure, no foreign bodies (tools,
parts etc.),
D
Vacuum clean and clean out the interior of the enclosures.
Remounting the
covers
Remove the covers as per the module (See G31--08.).
G31--080
Dismantling and reassembly
of the metal enclosure covers
(FKG1N/F).
G31--082
Dismantling and reassembly
of the metal enclosure covers
(FKG1XP/XV/XW).
Continued on next page.