Alstom FKG1X - Page 92

Packaging -
-
Shipping and storage
Packaging
-
-
Identificati
on
-
-
Storage
S22
-
-0
01EN05
3/6
02--2011
© ALSTOM 2010. All rights reserved. Informat
ion contained in
this document is indicative only. No
representati
on or
warrant
y is
given or should
be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liabili
ty and
is subject to
change without notice. Reproduction, use or disclosure to
third parties, without express writt
en authority, is
strictly prohibited.
 GRID
Identifying sub
-
-
assemblies and their packaging
Introduction
Each
circuit-
-breaker
sub-
-assembly
(poles,
operatin
g
mechan
ism,
etc.)
is
identified by a plate giving its reference numbers.
These numbers are marked on the packaging cases of each sub--assembly.
Example of marking
and
identifyin
g
-
-
Manufactu
rer refere
nce No
. = 100
928
-
-
Circuit-
-breaker identifi
cation No. 1
-
-
Pole N
o. 1
10
0
92
8
00
10
01 01
100 928 0010
n
o
SÉRIE
Rep. 1
MARKING OF
PACKAGING CASES
IDENTIFICATION OF SUB--AS-
SEMBLIES AND TOOLING
CIRCUIT--BREAKER
IDENTIFICA
TION
No.
MANUFACTURER
REFERENCE No.
CASE No.
1