Maintenance
Intervention on the operating mechanism
P51--3001EN/03
8/10
09--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Lubrication
Principl e
No lubricant is necessary later on. The support bearings and rollers were
greased in our workshops with special lubricant:
ASEOL SYLITEA 4--018
This grease supports low temperatures very well and is very age--resistant.
So these qualities are not altered during use, it is forbidden to
:
D Mix this grease with any other lubricant.
D Carry out subsequent lubrication using any other oil.
D Spray, over the equipment components, any anti--corrosion protective
liquid or lubricating oil whatsoever.
Mixing it with other lubricants cound cause the layer of grease to harden too
much.
To Next Page
Loading...
