Installation
Mounting the operating mechanism
P31--7901EN/02
1/8
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Presentation
Required product
MOBILPLEX 47 -- MOBILUX EP3 grease (greasing for the fasteners).
Tools required
ALSTOM Grid
List of ALSTOM Grid tools necessary for assembly :
Mark Illustration Description Quantity
(1) Hoisting strap 1
Lifting means
Provide an adequate means of hoisting (60 daN).
Instructions
The following table gives the steps for installing the operating mechanism
on the pole support:
Step Subject Page
A Preparing the operating mechanism 2
B Coupling the operating mechanism 3
C Low voltage electric wiring 5
D Returning to normal operating conditions 6
E Permanent heating 7
To Next Page
Loading...
