Installation
Mounting the operating mechanism
P31--7901EN/02
7/8
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Permanent heating
Instructions
Provide power for permanent heating of the operating mechanism (in
summer and winter) to avoid condensation and resulting corrosion risks.
TO AVOID RESETTING OF THE CLOSING SPRING DO NOT POWER
THE CONTROL MOTOR .
THE CIRCUIT--BREAKER MUST NOT BE ACTUATED AT AN SF
6
GAS
PRESSURE BELOW THE MINIMUM PRESSURE FOR ISOLATION p
me
.
To Next Page
Loading...
