P12y/EN FT/D22 Technical Guide
User Guide
Page 26/108 MiCOM P125/P126/P127
The following table shows the possible combinations by using on “Level” or
on “Edge”.
Setting configuration Input status
Active setting
group
Input active
High
Input active
Low
Change group
on Level
Change group
on Fall Edge
Input non
powered
Input
powered
Setting Group 1 X X X
Setting Group 2 X X X
Setting Group 1 X X X
Setting Group 2 X X X
Setting Group 1 X X L to H
Setting Group 2 X X L to H
Setting Group 1 X X H to L
Setting Group 2 X X H to L
CONFIGURATION
Heading of CONFIGURATION menu.
To gain access to the Inputs submenu, press 2, 6 until
the submenu is reached.
Alarms
Heading Alarm submenu.
To gain access to the submenu content, press 2.
Inst. Self-reset
Yes
To enable/ disable the auto acknowledge of the
instantaneous alarms.
To modify press 5 and using 8 2 keys Press 5 to
confirm the setting.
CONFIGURATION
Heading of CONFIGURATION menu.
To gain access to the Inputs submenu, press 2, 6 until
the submenu is reached.
Date
Heading type date submenu.
To gain access to the submenu content, press 2.
Date Format
PRIVATE
Press 5 to modify and use 8 2 to assign free format
date or IEC format date. Press 5 to confirm choice.
(This operation is seen from remote)
To Next Page
Loading...