Alstom MiCOM P127 - Page 75

Technical Guide P12y/EN FT/D22
User Guide
MiCOM P125/P126/P127 Page 73/108
Trip tIC>
No
Assigning the first trip threshold relevant to the phase C
to output relay RL1.
Setting choice: Yes, No
Trip tIe>
No
Assigning the first earth fault overcurrent trip threshold
to output relay RL1.
Setting choice: Yes, No
Trip tIe>>
No
Assigning the second earth fault overcurrent trip
threshold to output relay RL1.
Setting choice: Yes, No
Trip tIe>>>
No
Assigning the third earth fault overcurrent trip threshold
to output relay RL1.
Setting choice: Yes, No
Trip tPe/IeCos>
No
Assigning the first earth wattmetric trip threshold to
output relay RL1.
Setting choice: Yes, No
Trip tPe/IeCos>>
No
Assigning the second earth wattmetric trip threshold to
output relay RL1.
Setting choice: Yes, No
Trip tI2>
No
Assigning the first negative sequence overcurrent trip
threshold to output relay RL1.
Setting choice: Yes, No
Trip tI2>>
No
Assigning the second negative sequence overcurrent
trip threshold to output relay RL1.
Setting choice: Yes, No
Trip tI2>>>
No
Assigning the third negative sequence overcurrent trip
threshold to output relay RL1.
Setting choice: Yes, No
Trip Thermal q
No
Assigning the thermal overload trip threshold to output
relay RL1.
Setting choice: Yes, No
Trip tUe>>>>
No
Assigning the residual overvoltage trip threshold to
output relay RL1.
Setting choice: Yes, No