Sr. No Parameter Default setting Setting Range
This setting is used to turn on/off local time adjustments.
Fixed - A local time zone adjustment can be defined using the Local Time offset setting and all interfaces will use local time.
Flexible - A local time zone adjustment can be defined using the Local Time offset setting and each interface can be assigned to the
UTC zone or local time zone with the exception of the local interfaces which will always be in the local time zone.
Disabled - No local time zone will be maintained. Time synchronization from any interface will be used to directly set the master clock
and all displayed (or read) times on all interfaces will be based on the master clock with no adjustment.
3. Local Time
Offset
+000 -720 to + 720 mins step 15 mins
This setting is used to specify an offset of -12 to +12 hours in 15 minute intervals for local time zone. This adjustment is applied to the
time based on the master clock, which is in UTC/GMT.
4. DST Enable Yes Yes / No
This setting is used to turn on/off daylight saving time adjustment to local time.
5. DST Offset 60 From 30 to 60 mins step 30 mins
This setting is used to specify daylight saving offset which will be used for the time adjustment to local time.
6. DST Start Last First / Second / Third / Fourth / Last
This setting is used to specify the week of the month in which daylight saving time adjustment starts.
7. DST Start Day Sunday Sunday/Monday/Tuesday/Wednesday/Thursday/Friday/Saturday
This setting is used to specify the day of the week in which daylight saving time adjustment starts.
8. DST Start
Month
March January/February/March/April/May/June/July/August/September/
October/November/December
This setting is used to specify the month in which daylight saving time adjustment starts.
9. DST Start
Mins
60 0 to 1425 mins step 15 mins
This setting is used to specify the time of day in which daylight saving time adjustment starts. This is set relative to 00:00 hrs on the
selected day when time adjustment is to start.
10. DST End Last First / Second / Third / Fourth / Last
This setting is used to specify the week of the month in which daylight saving time adjustment ends.
11. DST End Day Sunday Sunday/Monday/Tuesday/Wednesday/Thursday/Friday/Saturday
This setting is used to specify the day of the week in which daylight saving time adjustment ends.
12. DST End
Month
October January/February/March/April/May/June/July/August/September/
October/November/December
This setting is used to specify the month in which daylight saving time adjustment ends.
13. DST End Mins 60 0 to 1425 mins step 15 mins
This setting is used to specify the time of day in which daylight saving time adjustment ends. This is set relative to 00:00 hrs on the
selected day when time adjustment is to end.
14. RP Time Zone UTC Local / UTC
UTC / Local (Setting for the rear port 1 interface to specify if time synchronization received will be local or universal time coordinated.).
15. SET Hours *** 00 to 23 hrs step 1
The Hour setting is needed when the relay is not connected to SCADA system.
16. SET Minutes *** 00 to 59 mins step 1
The Minutes setting is needed when the relay is not connected to SCADA system.
17. SET Seconds *** 00 to 59 step 1
The Seconds setting is needed when the relay is not connected to SCADA system.
18. SET Date *** 1 to 31 days step 1
The Date setting is needed when the relay is not connected to SCADA system.
19. SET Month *** 1 to 12 months step 1
The Month setting is needed when the relay is not connected to SCADA system.
To Next Page
Loading...
