2.2 Procedure for changing the setting of Parameters
2.2.1 General procedure for changing setting of any parameter (with alphabetic value)
Trip Test
Enabled
Step 1: Press the Edit Key the first alphabet of word will start blinking
and shall be displayed as follows.
Trip Test
Enabled
Step 2: By using the Plus / Up arrow key (+ /) or the Minus / Right
arrow key (- /) the desired Selection can be set as shown in the
display.
Trip Test
Disabled
Step 3: After setting press the Edit Key, the text will stop blinking and
move to next option.
Trip Test
Disabled
Step 4: Press the Left arrow key () it will ask if you want to save the
setting, and move to the next option.
SET For Save
RESET For Cancel
Step 5: When the SET key is pressed it will SAVE the changes, the OK
message is displayed and relay will return to the Main Menu.
If RESET key is pressed, it will CANCEL the changes and relay returns
to the Main Menu.
To Next Page
Loading...
