2.2.2 General procedure for changing setting of any parameter (with numerical value)
Password = 0000
Step 1: Press the Edit Key the last digit of the number will start blinking
and shall be displayed as follows.
By using the left arrow key () the blinking (number) selection can be
shifted from right to left.
Password = 0000
Step 2: By using the Plus / Up arrow key (+ ) or the Minus / Right
arrow key (- /) set the desired numerical Setting
Password = 0001
Step 3: After setting press the Edit Key, the Number will stop blinking
and move to next option.
Password = 0001
Step 4: When the Left arrow key () is pressed it will ask if you want to
save the setting and move to the next option.
SET For Save
RESET For Cancel
Step 5: When the SET key is pressed it will SAVE the changes, the OK
message is displayed and relay will return to the Main Menu.
If RESET key is pressed, it will CANCEL the changes and relay returns
to the Main Menu.
SYSTEM DATA
2.3 MENUS
2.3.1 Default Display
After Power ON or when the PROT. RESET & RESET/EDIT key is pressed; the relay will display the
following message.
P50 Agile P15D
This window will flash momentarily showing the following
Relay Name: P50 Agile P15D
Then the control will go automatically to next window
To Next Page
Loading...
