Trip Test
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Trip Test can set i.e. Enabled or Disabled.
After selecting the desired Trip Test press the Edit Key, the text will stop
blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Trip Block
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Trip Block can set i.e. Enabled or Disabled.
After selecting the desired Trip Block press the Edit Key, the text will
stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Latch Relay
Enabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Latch Relay can set i.e. Enabled or Disabled.
After selecting the desired Latch Relay press the Edit Key, the text will
stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Trip Test
Enabled
The window displays the first setting of the CB Control.
Press the Left arrow key () to move to the next option. *
SET For Save
RESET For Cancel
Press the SET / Left arrow key () to SAVE the changes.
Press the RESET key to CANCEL the changes. .
OK
When the SET / Left arrow key () is pressed the relay will SAVE the
changes and this window will flash for moment. The control will return to
the main menu.
CB CONTROL
Note:
* The User can scroll the previous settings by using the Plus / Up arrow key (+ /
).
** After Editing any sub menus of the CB Control setting, If the SET/ Left (
) arrow key is pressed, the Relay
ask SET to SAVE the changes or RESET to CANCEL the changes.
To Next Page
Loading...
