Alstom MiCOM P50 Agile P15D - Page 49

P50 Agile P15D
5 Configuration
P15D/EN TM/B
5-13
A=0000 A
B=0000 A
This window shows actual Primary load current as per the CT Primary
selection.
Press the Plus / right arrow key (+ /) to move to the next option.
C=0000 A
N=0000 A
This window shows actual Primary load current as per the CT Primary
selection.
Press the Plus / right arrow key (+ /) to move to the next option.
a=00.00 b=00.00A
c=00.00 n=00.00A
This window shows actual Secondary load current.
Press the Plus / right arrow key (+ /) to move to the next option.
Thermal State
0000%
This window shows actual Thermal State.
Press the Plus / right arrow key (+ /) to move to the next option.
A=0000 A
B=0000 A
The window displays the first Measurement parameters.
Press the Left arrow key () or Minus / Right arrow key (- /) to return
to the Main Menu.
MEASUREMENT
2.3.4 CB CONTROL MENU
2.3.4.1 Edit settings
CB CONTROL
Password protected window for “CB CONTROL” settings i.e. Trip Test,
Trip Block and Latch Relay.
Press the Left arrow key () to move to the next option.
Password = 0001
Press the Edit Key, the number will start blinking.
Enter the previously set password by using the Plus / Up arrow key (+
/) or the Minus / Right arrow key (- /). The Password setting range
is 0000 to 9999. The Default Password is “0000”
After editing the Password press the Edit Key, the number will stop
blinking.
Press the Left arrow key () to move to the next option.