Note:
#. If the function is set as enable then the relay will allow editing the settings of respective sub menus. If the
function is set as disable then the relay will not allow editing the settings of sub menus and will bypass the
protection function.
* The User can scroll the previous settings by using the plus / Up arrow key (+ /
).
** After Editing any sub menus of the Earth Fault setting, If the SET/ Left (
) arrow key is pressed, the Relay
ask SET to SAVE the changes or RESET to CANCEL the changes.
Note:
The settings of IN>2 Function and IN>3 Function to be set in similar manner as that of IN>1 Function.
2.3.14 GROUP 1-THERMAL OVERLOAD SUB MENU
2.3.14.1 Edit settings (if Thermal Overload function is disabled)
Thermal Overload
By using the Plus / Up arrow key (+ /) or Minus / Right arrow key (-
/) select the Thermal Overload setting menu in Group 1.
Press the Left arrow key () to move to the next option.
Characteristic
Disabled
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Characteristic can set i.e. Single / Disable. #
After selecting the desired Characteristic press the Edit Key, the text will
stop blinking.
Press the Left arrow key () to move to the next option. *
SET For Save
RESET For Cancel
Press the SET / Left arrow key () to SAVE the changes.
Press the RESET key to CANCEL the changes.
OK
When the SET / Left arrow key () is pressed the relay will SAVE the
changes and this window will flash for moment. The control will return to
the Main Menu.
To Next Page
Loading...
