Time Constant 1
001.00
Press the Edit Key, the number will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired Time Constant 1 can be set. The setting range is from
001 to 200 in steps of 1.
After editing the desired Time constant 1 press the Edit Key, the number
will stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
K
1.05
Press the Edit Key, the number will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired K Constant can be set. The setting range is from 1.00
to 1.50 in steps of 0.01.
After editing the desired K Constant press the Edit Key, the number will
stop blinking. **
Press the Minus / Right arrow key (- /) to move to the next option. *
Thermal Trip
1.00 A
The window displays the first setting of the thermal overload menu.
Press the Left arrow key () the relay show as follows
SET For Save
RESET For Cancel
Press the SET / Left arrow key () to SAVE the changes.
Press the RESET key to CANCEL the changes.
OK
When the SET / Left arrow key () is pressed the relay will SAVE the
changes and this window will flash for moment. The control will return to
the Main Menu.
GROUP 1
Note:
#. If the function is set as enabled then the relay will allow editing the settings of respective sub menus. If the
function is set as disabled then the relay will not allow editing the settings of sub menus and will bypass the
protection function.
* The User can scroll the previous settings by using the Plus / Up arrow key (+ /
).
** After Editing any sub menus of the Thermal Overload setting If the SET/ Left (
) arrow key is
pressed, the Relay ask SET to SAVE the changes or RESET to CANCEL the changes.
To Next Page
Loading...
