Alstom MiCOM P50 Agile P15D - Page 89

P50 Agile P15D
5 Configuration
P15D/EN TM/B
5-53
I>3 Status
Enable
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired I>3 Status can be set i.e. Enable / Block. #
After selecting the desired I>1 Status press the Edit Key, the text will
stop blinking.
Press the decrement / Right arrow key (- /) to move to the next option.
IN>1 Status
Enable
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired IN>1 Status can be set i.e. Enable / Block. #
After selecting the desired I>1 Status press the Edit Key, the text will
stop blinking.
Press the Minus / Right arrow key (- /) to move to the next option.
IN>2 Status
Enable
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired IN>2 Status can be set i.e. Enable / Block. #
After selecting the desired I>1 Status press the Edit Key, the text will
stop blinking.
Press the Minus / Right arrow key (- /) to move to the next option.
IN>3 Status
Enable
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired I>3 Status can be set i.e. Enable / Block. #
After selecting the desired I>1 Status press the Edit Key, the text will
stop blinking.
Press the Minus / Right arrow key (- /) to move to the next option.
SET For Save
RESET For Cancel
Press the SET / Left arrow key () to SAVE the changes.
Press the RESET key to CANCEL the changes.
OK
When the SET / Left arrow key () is pressed the relay will SAVE the
changes and this window will flash for moment. The control will return to
the main menu.
GROUP 1