Note:
#. If the function is set as enabled then the relay will allow editing the settings of respective sub menus. If the
function is set as disabled then the relay will not allow editing the settings of sub menus and will bypass
the protection function.
* The User can scroll the previous settings by using the Plus / Up arrow key (+ /
).
** After Editing any sub menus of the Cold Load Pickup setting, If the SET/ Left (
) arrow key is pressed, the
Relay ask SET to SAVE the changes or RESET to CANCEL the changes.
Note :
The settings ( I>1, I>2, I>3, IN>1, IN>2 and IN>3) which are to be enabled in OVERCURRENT and EARTH
FAULT function of Group setting, only those settings are visible in COLD LOAD PICKUP.
2.3.15.2 Edit settings (For I>1, IEC or IEEE Curves are selected)
Cold Load Pickup
By using the Plus / Up arrow key (+ /) or Minus / Right arrow key (-
/) select the Cold Load Pickup setting menu in Group 1.
Press the Left arrow key () to move to the next option.
tcold Time Delay
07200
Press the Edit Key, the number will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired tcold Time Delay can be set. The setting range is from
00000 to 14400 in steps of 1.
After editing the desired tcold Time Delay press the Edit Key, the
number will stop blinking.
Press the Minus / Right arrow key (- /) to move to the next option.
tclp Time Delay
07200
Press the Edit Key, the number will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired tclp Time Delay can be set. The setting range is from
00000 to 14400 in steps of 1.
After editing the desired tclp Time Delay press the Edit Key, the number
will stop blinking.
Press the Minus / Right arrow key (- /) to move to the next option.
I>1 Status
Enable
Press the Edit Key, the text will start blinking.
By using the Plus / Up arrow key (+ /) or the Minus / Right arrow key (-
/) the desired I>1 Status can be set i.e. Enable / Block. #
After selecting the desired I>1 Status press the Edit Key, the selectable
text will stop blinking.
Press the Left arrow key () to move to the next option.
To Next Page
Loading...
