POWERWAND™
Honeycomb Shades | Dual Shades | Roller Shades | Window Shadings
QUICK PROGRAMMING GUIDE
1a. Attach the Wand 1b. Attach the Wand — Honeycomb Shades
2. Operate the Wand
On Dual Shades, Roller Shades and Window Shadings, with the wand control
buttons facing you, attached the top of the wand on the metal hook support
(1) on the motor control side, then connect the cable into the motor head (2).
On Honeycomb shades, the wand will be already connected to the shade (1).
With the wand control buttons facing you, attached the top of the wand into
the plastic hook support on the motor control side (2).
Important: Before starting the programing, install the shade following the installation instructions provided.
For Honeycomb Shades, connect the battery cable into the slot located in the endcap, inside the headrail, before hanging the shades on the brackets.
Roller and Honeycomb Mode:
• Press the DOWN or UP button to lower or raise the shade. Press the STOP to stop the shade at the desired position.
Window Shadings and Dual Shades Mode:
• Tapping the UP or DOWN button for less than 2 seconds will move the shade in short steps.
• Holding the UP or DOWN button down for more than 2 seconds before releasing will operate the shade at the standard speed.
• Press the STOP button to stop the shade at the desired position.
1
2
1
2
STOP
UP
DOWN
MICRO USB
CHARGING PORT
Front of wand Back of wand
PROGRAMMING
BUTTON
LED
1
To Next Page
Need help?
General
