WOOD & FAUX BLINDS
Tilt Only
INSTALLATION INSTRUCTIONS
1b. Install the Brackets — Outside Mount
1a. Install the Brackets — Inside Mount
1c. Using Extension Brackets (optional) 2. Install the Blind
Install each bracket with two screws, either through the side or up through
the top. Minimum 1 1/8” mounting surface height requirement.
For Intermediate Bracket (if required), space evenly between the two end
brackets. Make sure all brackets are leveled and aligned.
For Flush Mount with Valance, the minimum is 3 1/2” for 1 3/8” and 2” slat
and 3 7/8” for 2 3/8” and 2 1/2”slats.
First, mark where the ends of the headrail will be positioned. Then, install
each bracket with two screws through the back. Minimum 1 3/4” mounting
surface height requirement.
For Intermediate Bracket (if required), space evenly between the two end
brackets. Make sure all brackets are leveled and aligned.
Important: On 2-3/8” & 2-1/2” slats, spacer blocks will be attached to the
end of each bracket (if extension brackets are not used).
Position the extension brackets to the wall markings made on step 1.
The bracket tops must be aligned and level to one another.
First, mount the extension brackets with screws through diagonal holes.
Attach the installation brackets to the extension brackets. Then, mark where
the ends of the headrail will be positioned and install each bracket with two
screws either through the back.
For Intermediate Bracket (if required), space evenly between the two end
brackets. Make sure all brackets are leveled and aligned.
First, open the installation brackets door latches by pressing up on the
bracket bottoms while lifting the doors open. Then, slide the headrail into
the brackets and push it all the way back. The front lip of the headrail should
hook to the center support lips (if installed). Finally, snap the door shut over
the locking tab to secure it.
Right Hand
Bracket
Left Hand
Bracket
Right Hand
Bracket
Left Hand
Bracket
Intermediate Bracket
(optional)
Spacer Block
(if necessary)
3
/
8
”
1
1
Side or Top Installation
Intermediate Bracket
(optional)
2
3
Click