5
PROFESSIONAL POWER AMPLIFIERS ADVANTAGE SERIES
EARTH LINK SWITCH.
INPUT SIGNAL CONNECTOR XLR-3-31.
STEREO/ BRIDGE SWITCH.
XLR-3-32 OUTPUT SIGNAL CONNECTOR.
(ONLY WITH THE OPTIONAL CROSSOVER CARD FITTED).
INPUT SIGNAL SELECTOR FOR EACH CHANNEL.
(ONLY WITH THE OPTIONAL CROSSOVER CARD FITTED).
3. WORKING PRECAUTIONS
The manufacturer cannot be held responsible for any damage that is incurred by not using the
power amplifier in compliance with the warranty or working precautions.
DANGER: High voltage inside the amplifier. ! Do not open !. The power amplifier doesn't
contain parts that can be repaired by the user. The power amplifier could have electric
power stored in their interior even disconnected it from the mains.
CAUTION: Protect the power amplifier from the rain and moisture. Ensure that no
objects or liquids enter it. If liquid is spilled into the power amplifier, disconnect the power
amplifier from the mains and consult a qualified service technician.
Don't place the power amplifier close to sources of heat. Also make sure that the front and the rear
panel there are free of obstructions, since the fan could not work properly and cause the thermal
protection work.
DANGER: The power amplifier output connectors could have high voltage. Make sure of turning off
the power amplifier before handling on these output connectors.
4. INSTALLATION
UNPACKING
Before leaving from factory, each power amplifier was carefully inspected and tested. Unpack
and inspect the power amplifier for any damage that may have occurred during shipment. If any
damage is found, doesn't connect the power amplifier to the mains, notify the salesperson
immediately, because the unit must be inspected by a qualified service technician.
To Next Page
