Nieuwland Parc 159
3351 LJ PAPENDRECHT
Nederland
+31 (0)78 615 20 33
info@altec.nl
www.altec.nl
Erasmuslaan 11
1804 EPPEGEM
België
+32 (0)2 270 34 88
info@altec.be
www.altec.be
Installation: ink ribbon & labels
4. Install labels
I. Place your roll of labels
on the green label spindle
and center it with the green
wings.
K. Move the labels below
the white bar and center
the green guides with both
hands to the sides of the
label roll. The right guide is
the gap sensor.
L. Make sure there is no
movement between the
labels and the guides. Also
make sure the guides are
not too tight.
J. Place the label spindle
with the labels in the
notches at the back of the
TTP printer.
M. If the label roll ha a
notch or detection hole, the
black mark sensor must be
used (the green guide at the
bottom of the printer). Make
sure the sensor eyes (black
rectangle) are positioned
directly below the nodge.
The black mark sensor can
be moved from left to right.
N. Feed the labels until
they reach the metal edge
at the front of the printer.
Now close the printer by
lifting it out of its lock and
pushing it down gently until
it clicks.
O. Close the transparent
cover.
To Previous Page
Loading...
