Visit our website at www.fantomskateboard.com for replacement parts and technical support. 7
Before You Start Cont.
CHARGING THE BATTERY
Required components- Battery Charger
- Initial battery charge time - 12 hours
- Recharges after initial charge - up to 10 hours
- Batteries need to be charged on a monthly basis when
not in use to maximize performance and battery life.
1. Make sure power switch is in the OFF
position before plugging in the charger.
Insert charger into charging port on the
right side of the battery box.
2. Plug the battery charger into a wall power
outlet. The light on the charger housing
should illuminate. Red LED light indicates
battery is charging and a green LED light
indicates battery is fully charged.
WARNING: Any changes or modications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to operate the
equipment.
WARNING: Battery must be fully charged before you ride your skateboard.
FCC INSTRUCTION
Please note that changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1- This device may not cause harmful interference.
2- This device must accept any interference received, including interference that may
cause undesired operation. This equipment should be installed and operated with a
minimum distance 20cm between the radiator and your body.
LED Light
Indicator