QUICK START
Getting setup is easy. There are two brackets that connect to the back of the trapKAT. These brackets
in turn get mounted onto the brackets on your rack stand. Once you set the mounting brackets on your
stand and lock them in, setting up the trapKAT will only take seconds to set up.
The trapKAT uses a screw in style power adapter (different from other KAT models). This adapter
is universal so it can be used all throughout the world. Simply plug it in and turn it on.
Plug the eKIC (or another Bass Drum Trigger) into the “BASS DRUM INPUT” on your trapKAT.
It requires a standard 1/4” mono cable.
Plug the eHAT2 (or another Hi Hat Controller) into the “HAT INPUT” on your trapKAT. It also
requires a standard 1/4” mono cable
Plug the supplied footswitch into the “KIT SELECT”
Connect your sound source to the trapKAT by connecting a standard MIDI cable (hardware based) or
USB to MIDI cable (software based) to the trapKAT's MIDI OUT connector. If you have purchased a
sound module and trapKAT together from Alternate Mode, The trapKAT will be preprogrammed for
that sound module.
The trapKAT is now ready to play.
Notice that there are twenty four pads on the trapKAT. The trapKAT also has 24 Kits to play on. Each
pad represents a number from 1 to 24. Every time you step on the footswitch, you jump to the next
kit, from 1 to 24. You can instantly jump to any kit simply by holding down the Kit Select footswitch,
and while held down, tap on any one of the pads. When you do this, the trapKAT calls up the KIT
number that matches the pad number.
You are now ready to stop reading and start enjoying yourself. Please get behind the trapKAT and
start playing!!!!!!
9
To Next Page
Loading...