9
Operating instructions GB
3.5 End of operation
Turn to position O
Danger of scalding! Never dismount
the high pressure hose or the water inlet
hose while the machine is in operation.
Disconnect the cleaner, shut off the
water supply and activate the spray
handle before dismounting the high
pressure hose or the water inlet hose.
Turn start button on control panel to position O. Unplug.
Shut off the water supply and activate the spray handle.
Dismount the high pressure hose and the water inlet hose.
Only 40C: If the motor protection system engages, the machine should be restarted in position O.
NOTE: Machines with automatic start/stop - 40CA
When the spray handle is released, the machine will automatically stop after approximately 10 sec.
The machine can be restarted just by activating the spray handle.
3.6 Transport directions
Lifting points: handle and under the edge
of fender
When transporting the machine, lifting by crane should be undertaken; lift by both handles using a lifting
strap. When lifting by hand - use the handles and under the edge of the fender.
3.7 Storage
Frost-free room or anti-freeze solution
Prior to storing the machine should be completely emptied of water as follows: Detach the inlet hose and
the high pressure hose and start the machine. Let the machine run for approximately 3 minutes until all
water has run out of the pump system.
If the room is not frost-free the machine should be protected with an anti-freeze solution.
To Next Page
Loading...
