Need help?Do you have a question about the Alto SR400A and is the answer not in the manual?
General| Crossover Frequency | 2.2 kHz |
|---|---|
| Maximum SPL | 126 dB |
| Output Connector | XLR |
| Enclosure | Polypropylene |
| Impedance | 8 ohms |
| HF Driver | 1" (25 mm) compression driver |
| Amplifier Power | 400W peak |
| Frequency Response | 55Hz - 20kHz |
| Input Connectors | XLR, TRS |
| Mounting | Pole mount |
| Sensitivity | 98dB |
| Tweeter Size | 1" |
| Weight | 33.1 lbs |
| Type | 2-way active loudspeaker |
Specifies the required input voltage and frequency for the unit.
Defines the expected audio output power under specified load conditions.
Defines the minimum input signal level required for a standard output.
Quantifies the ratio of desired audio signal to unwanted noise.
Details Total Harmonic Distortion (THD) at different output levels.
Graphs the audio output level across the audible frequency spectrum.
Inspects the unit for correct assembly, component values, and insulation.
Covers basic power-up checks, voltage verification, and signal output symmetry.
To Next Page