Alto TS212 User Manual

21
Appendix (English)
Technical Specifications
Specifications are subject to change without notice.
TS210
Output Power
1100 W peak (700 LF + 400 HF)
550 W continuous RMS (350 LF + 200 HF)
Low Frequenc
y
10” (254 mm) woofer, 2” (51 mm) voice coil
High Frequenc
y
1” (25mm) exit with 1” (25 mm) neodymium compression driver
Crossover
2.5 kHz
Maximum SPL 125 dB peak, 122 dB continuous (dB-SPL @ 1 m)
Frequency Response
54 Hz – 20 kHz (+ 3 dB)
Frequency Range 48 Hz – 22 kHz (-10 dB)
Coverage
80/100° H x 60° V nominal
Connectors
(2
)
1/4” (6.35 mm) TRS or XLR inputs
(1) XLR link output
Cabinet Trapezoidal, injection-molded, polypropylene enclosure, with perforated steel grille
Controls
Volume, power on/off with LED, clip limiter with LED, ground lift
Protection Electronic clip, thermal and transducer overdrive protection
Power
AC Input: 100–120/220–240 V, 50/60 Hz
Fuse: 100-120 V T6.3AL AC250V / 220-240 V T3.15AL AC250V
Dimensions
(width x depth x height)
12.72” x 12.0” x 20.76”
323 x 305 x 527 mm
Weight
21.98 lbs.
9.97 kg
TS212
Output Power
1100 W peak (700 LF + 400 HF)
550 W continuous RMS (350 LF + 200 HF)
Low Frequency 12” (305 mm) woofer, 2” (51 mm) voice coil
High Frequenc
y
1” (25 mm) neodymium driver
Crossover 2 kHz
Maximum SPL
127 dB peak, 124 dB continuous (dB-SPL @ 1 m)
Frequency Response 53 Hz – 20 kHz (+ 3 dB)
Frequency Range
46 Hz – 22 kHz (-10 dB)
Coverage 80/100° H x 60° V nominal
Connectors
(2) 1/4” (6.35 mm) TRS or XLR inputs
(1) XLR link output

Alto TS212 Specifications

General

Power Output	550W continuous, 1100W peak
Max SPL	125 dB
LF Driver	12" Woofer
HF Driver	1 inch (25.4 mm) neodymium driver
Input Types	2 x XLR/TRS combo
Outputs	1 x XLR output
Enclosure	Trapezoidal, injection-molded polypropylene
Mounting	Pole mountable
Type	Active 2-way PA Speaker