Need help?Do you have a question about the Alto ts115a truesonic and is the answer not in the manual?
Power| output power continuous | 400 W |
|---|---|
| output power peak | 800 W |
| power supply voltage | 100-120V/220-240V |
| power supply frequency | 50/60 Hz |
| inrush current at initial switch-on | 3.61 A |
| inrush current after power supply interruption | 3.91 A |
Audio Specifications| crossover frequency | 2 kHz |
|---|---|
| max SPL continuous | 122 dB |
| max SPL peak | 125 dB |
| frequency response | 48 Hz – 18 kHz |
Driver Specifications| low frequency driver size | 15" (381 mm) |
|---|---|
| low frequency voice coil | 2" (51 mm) |
| high frequency driver size | 1" (25 mm) |
Connectivity| input connector | 1/4" TRS or XLR |
|---|---|
| link connector | XLR |
Weight and Dimensions| dimensions (H x W x D) | 26.7" x 16.9" x 15.2" (679 mm x 430 mm x 385 mm) |
|---|---|
| weight | 48.6 lbs (22 kg) |
Speaker should be installed on a stand or suspended from suspension points (M10 x 1.5PH). Avoid suspending multiple speakers vertically.
Connect power cable to POWER INPUT. Set POWER SWITCH to 'off' when connecting/disconnecting.
Adjust VOLUME knob. POWER LED indicates power status. SIGNAL LIMIT LED shows clipping.
Use standard cables for INPUT (sound source) and MIX OUT (link to another speaker).
CONTOUR switch boosts highs/lows. GROUND SWITCH reduces hum or noise.
To Next Page
