EasyManua.ls Logo

Altrad BELLE RTX 50 - User Manual

Altrad BELLE RTX 50
52 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
• Spare Parts Book
• Pièces Détachées
870/10014/3
06/17
Operators Manual
Manuel De L'Opérateur
GB
F
300
BELLE
RTX RAMMERS
RTX PILONNEUSES
6
34

Table of Contents

Questions and Answers

  • N
    Nicole LeeAug 9, 2025
    How to start Altrad Vibratory rammers & tampers when the engine won't start?
    • K
      Kimberly TranAug 9, 2025
      If the Altrad Vibratory rammers & tampers engine won't start, check the following: * Ensure the fuel tank is filled. * Make sure the fuel tap is open. * If it's a GX100 model, prime the engine by pushing the Carburettor Primer Bulb 4 times and then pull the Recoil Handle until the engine fires. * For diesel models, consult the Service & Maintenance section of the manual. * If it's a petrol engine, inspect the spark plug for contamination or damage and replace if necessary. * A faulty carburetor could also be the culprit, so service the carburetor.
  • Y
    yspencerAug 23, 2025
    What to do if Altrad Vibratory rammers & tampers engine stops suddenly?
    • C
      Courtney RiceAug 23, 2025
      If the Altrad Vibratory rammers & tampers engine stops suddenly or when the engine RPM is increased, consider these possibilities: 1. Refer to the information provided earlier. 2. If it's a GX120 model, the main jet of the Carburettor might be clogged with dirt. Remove the main jet and clean it with compressed air. 3. The air filter element could be dirty, so clean it. 4. If it's a petrol engine, the spark plug cap might be loose. Tightly fit the cap to the plug.

Altrad BELLE RTX 50 Specifications

General IconGeneral
Impact force10 kN
Operating speed20 m/min
Plate size280 x 280 mm
Shoe Size280 x 280 mm
Tamping Foot Size280 x 280 mm

Related product manuals