13
Enter TS Ratio
Enter ratio that it takes to move ET of vehicle 0.01 sec. (EX: 2 means it
is a 2:1 ratio or takes two 0.02 to move car 0.01 in ET)
View Values:
Allows you to view your base values and ratios.
Predict with
DA=1 OA=2
ADR=3 VP=4
Now you must choose which weather variable to reference your
prediction against. DA is the standard.
Wind Prediction:
If you have chosen Multiple Run Prediction you will be prompted to
select to use wind correction in the ET or TS predictions:
Predict w/Wind?
PRESS 1=Y 2=N
If you enable wind correction you will be prompted to select a vehicle
type:
Select Car Type
Dragster=1
Door =2
Roadster=3
Next you can adjust the wind effect.
Adjust Effect?
Press 1=Y 2=N
Wind factors have been programmed to correct prediction for wind based
on speed and direction of wind. You can further adjust the amount of
correction by selecting to Adjust Effect:
Enter Value
Default (5)
(1-10)=
Selecting <5 means you are lessening and >5 increasing the wind
correction.
The information in this box is only relevant if your unit is OXYGEN SENSOR
EQUIPPED.
To Next Page
Loading...