20 / EN
Dryer / User Manual
Operating the product
5
.
5 Auxiliary functions
Audible warning
Drying machine makes an audible warning
when the program is completed. If you don’t
want it to make an audible warning, press the
“Buzzer” button. When you press the Buzzer
button, a light will illuminate and no audible
warning will be made when the program
ends.
C
You can select this function
before or after the program
starts.
End time
If you prefer to dry your laundry at a later
time, you can delay start time of the program
up to 3 hours, 6 hours or 9 hours using the
Delay function.
Open the loading door and place the laundry.
Select the drying program.
Press the End Time selection button and
set the delay time you wish. When the End
Time button is pressed once, 3 hours delay is
selected and the delay indicator will light up.
If you press the same button again, 6 hours
delay will be selected and when you press for
the third time, 9 hours delay will be selected.
If you press the End Time button once again,
the delay will be cancelled.
After the End Time selection is made, start
delayed running for the program selected
pressing the “Start/Stand-by” button.
C
You can add or remove laundry
within end time. At the end of
the Time Delay countdown, the
Time Delay warning indicator
turns off and drying begins
Changing the end time
If you want to change the duration during
the countdown:
Cancel the program by turning the On/Off/
Program selection knob. Select the program
you want and repeat the End Time selection
process.
Cancelling the end time function
If you want to cancel the end time
countdown and start the program
immediately:
Cancel the program by turning the On/Off/
Program selection knob. Select the program
you want and press the Start/Stand-by
button.
5.6 Warning indicators
C
Warning indicators may vary
depending on the model of your
dryer.
Filter cleaning
When the program is completed, the warning
indicator for filter cleaning turns on.
Water tank
When the program is completed, the warning
indicator to empty the water tank turns on.
If the water tank fills up while the program
continues, the warning indicator starts
flashing and the machine goes into stand-by.
In this case, empty the water tank and start
the program by pressing the Start / Stand-
by button. Warning indicator turns off and
program resumes.
Filter drawer /Heat exchanger
cleaning
When the programme is finished, the
cleaning symbol of the heat exchanger or
filter drawer may light up.
5.7 Starting the program
Press the Start/Stand-by button to start the
program.
Drying indicator will light up, indicating that
the program has started.
5.8 Child Lock
The drying machine has a child lock which
prevents the program flow from being
interrupted when the buttons are pressed
during a program. When the child lock is
activated, all buttons on the panel except
the On/Off/Program selection knob are
deactivated.
To Next Page
Loading...