ALTUS ADC70W - Maintenance and Cleaning; Lint Filter and Loading Door Inner Surface; Cleaning the Sensors

23 / EN
Dryer / User Manual
6 Mantenance and cleanng
Service life of the product extends and
frequently faced problems decrease if
cleaned at regular intervals.
6.1 Lint Filter / Loading Door
Inner Surface
Lint and fiber released from the laundry to
the air during the drying cycle are collected in
the Lint Filter.
A
Always clean the lint filter and
the inner surfaces of the loading
door after each drying process.
C
You can clean the lint filter
housing with a vacuum cleaner.
To clean the lint filter:
1. Open the loading door.
2. Remove the lint filter by pulling it up and
open the lint filter.
3. Clean lint, fiber, and cotton raveling by
hand or with a soft piece of cloth.
4. Close the lint filter and place it back into
its housing.
C
A layer can build up on the filter
pores that can cause clogging of
the filter after using the machine
for a while. Wash the lint filter
with warm water to remove the
layer that builds up on the lint
filter surface. Dry the lint filter
completely before reinstalling it.
C
Clean the entire inner surface of
the loading door and loading door
gasket.
6.2 Cleaning the sensors
There are dampness sensors in the machine
that detect whether the laundry is dry or not.
To clean the sensors:
1. Open the loading door of the machine.
2. Allow the machine to cool down if it is
still hot due to the drying process.
3. Wipe the metal surfaces of the sensor
with a soft cloth, dampened with vinegar
and dry them.
C
Clean metal surfaces of the
sensors 4 times a year.