6
Communicating with APS-3
For Wireless Bluetooth® communications with the APS-3 follow
the steps below with a Controller (Allegro², Archer², ...). Refer
to APS-3 User Manual for variations in controllers.
1. Turn on the APS-3. The red LED will turn on and the green
LED below the satellite icon starts to flash.
2. Turn on the Controller and Run data collection software.
For SurvCE go to step 3. For FIELDGenius go to step 6.
3. SurvCE: Go to the Equip tab and select GPS Rover.
4. In the Current Tab, select Manufacturer and Model.
5. In the Comms Tab, select Bluetooth as the Type. Select the
Configure button. Select Find Receiver, and a Bluetooth® Device
search occurs. Highlight the APS-3 name then select the
Bluetooth® button to bond.
6. FIELDGenius: In the Instrument selection screen, select GPS Rover
and select Edit.
7. Select Model and Communication. Choose the Make & Model.
Select Bluetooth Search and a Bluetooth® Device search occurs.
Select the APS-3 name, enter Bluetooth pin ‘default’, select OK,
then select Connect to bond.
Serial cable communication takes precedence over
Bluetooth®. Remove serial cable from SER 1 port for
Bluetooth to resume.
Be sure to select the appropriate APS-3 model.
The model is indicated by the product serial number.
Select APS-3 for 10XXX series and APS-3 V2 for 20XXX series.
To Next Page
Loading...