Alva GHP20 - Side

Place the control knob onto the M4x10 screw. Hang the chain to
the hole on the control box assembly and align the hooks of the
front panel to the holes in the bottom plate.
Place the gas cylinder inside the heater. Secure the cylinder with
the block belt tightly. Perform a leak test before use.
11
STEP 10
STEP 11
Warning :
Ensure the hose does
not make contact with
any high temperature
surfaces, or it may
melt and leak causing
The LP regulator/hose
assembly must be
located out of path-
ways where people
may trip over it or in
an area where the
hose will not be
subject to accidental
damage.
KK
LL
H
MM