IS-300CA INVERTER POWER SUPPLY
xii 990-418
WARNING
Do NOT put your hands or fingers between the electrodes.
When welding, keep your hands and fingers away from the electrodes.
Do NOT touch any welded part or electrode during, or just after welding.
The welded parts and electrodes are very hot. If you touch them you will be burned.
Ground the equipment.
If the equipment is not grounded, you may get an electric shock.
Use a ground fault breaker.
Use a ground fault breaker to prevent an electric shock.
Only use specified cables.
A cable with insufficient capacity or loose connections can cause electric shock or fire.
Do NOT use a damaged power cable, connecting cables, or plugs.
Do not step on, twist, or tense any cable. The power cable and connecting cables may be
damaged which can cause electric shock, short circuit, or fire. If any part needs to be repaired
or replaced, consult Amada Weld Tech or your distributor.
Stop operation if any trouble occurs.
If you detect a burning smell, abnormal sounds, abnormal heat, smoke, etc., turn power OFF
immediately to prevent fire or electric shock. Contact Amada Weld Tech or your distributor
People with pacemakers MUST stay away from the Power Supply.
When the Power Supply is operating, it generates a magnetic field, which adversely affects
pacemakers. People who use a pacemaker must not approach the Power Supply, or walk
around the welding shop while the Power Supply is operating, unless their medical doctor
has deemed it safe to do so.
Wear protective gear.
Put on protective gear such as protective gloves, long sleeved jacket, and leather apron to
avoid being burned.
To Next Page
Loading...