April 1998 93 RS5290000 Rev. 0
Kit Instructions
26. Dispenser Models
Push water tube into plastic union nut and tighten
union nut by hand. Gently pull on tube to confirm
nut is tight. Tighten water tube clamp screw.
Caution
To avoid property damage, confirm water tube union
nut is secure before replacing toe grille.
27. Electronic Control Models
Plug wiring harness into voltage box in center of
refrigerator cabinet behind toe grille. Snap wiring
harness into plastic retainer clips on bottom of
refrigerator cabinet. Align hole in plastic door
closure with hole in bottom hinge. Insert and tighten
screw.
28. Replace toe grille by inserting clips in holes and
snapping in.
To Next Page
Loading...
