Need help?Do you have a question about the Amann Girrbach Straumann Argotherm and is the answer not in the manual?
Explains warning symbols and signal words like NOTE, CAUTION, WARNING, DANGER.
Lists symbols used in the manual and their meanings for operation.
Covers DANGER, WARNING, CAUTION, and NOTE for hazards and safe operation.
States that only trained personnel should operate the machine.
Details the furnace, delivery scope, intended use, and CE conformity.
Identifies physical components and interfaces on the furnace from the front.
Identifies rear components and explains the operating level display.
Details configuration display and program shortcut keys.
Covers delivery scope, use, and components of the sintering compartment.
Instructions for positioning and preparing the furnace setup location.
Steps to safely remove and re-attach the furnace cover.
Detailed instructions for installing the heating rods carefully.
Steps to install the exhaust air pipe correctly.
Instructions for re-attaching the furnace cover after maintenance.
Guides on installing the sintering base and connecting its gas hose.
Instructions for connecting the protective gas supply.
Requirements and steps for connecting the compressed air supply.
Guidelines for safely connecting the furnace to the power supply.
Procedures for testing furnace functions before production use.
How to verify the protective gas flow and settings.
Verifies gas flow and describes pressure adjustment.
How to test the compressed-air cooling function.
Steps for preparing the sintering bowl and pearls for use.
Instructions on placing the sintering cover and the unit to be sintered.
Safe handling of the sintering bowl using tongs to prevent drops.
How to correctly place the protective gas retort for proper sealing.
Steps to execute the sintering program, including gas pressure and program selection.
Steps to complete the sintering process and shut down safely.
Safety precautions, cleaning methods, and routine checks for the furnace.
Recommended monthly cleaning and inspection for the furnace.
Instructions for cleaning and maintenance of the sintering compartment.
Guidance on identifying and reporting malfunctions to technical service.
Steps for replacing heating rods, thermoelements, and fuses.
Steps for replacing heating rods, thermoelements, and fuses.
Details on warranty provisions and exclusions for the product.
Information on environmentally friendly packaging and equipment disposal.
Lists technical data such as dimensions, weight, and electrical requirements.
Catalog of available accessories and replacement parts with article numbers.
General| Category | Dental equipment |
|---|---|
| Manufacturer | Amann Girrbach |
| Model | Straumann Argotherm |
| Cooling time from 250°C to 100°C | Approx. 15 min |
| Power supply | 230V, 50/60Hz |
To Next Page
