Amano Pioneer Eclipse 225FP16TR - Maintenance and Troubleshooting; Scheduled Maintenance Checklist; Common Troubleshooting Solutions

11
Machine Troubleshooting
Problem Possible Cause Solution
Check the main power supply (building circuit breaker).
Check the cord connection at the wall outlet
Switch lever safety lock not depressed Hold in the switch lever safety lock and then engage switch levers.
Bad connection Check the motor and cord interlock connections.
GFCI tripped Push the reset button. If problem continues, contact an authorized APEC distributor
Bad motor start capacitor Contact an authorized APEC Distributor.
Defective motor start switch Contact an authorized APEC Distributor.
Using extension cord with wire smaller than 12/3. Replace with a 12/3 extension cord.
Using more than one extension cord. Only use one 50ft 12/3 extension cord.
Bad motor run capacitor Contact an authorized APEC Distributor.
Defective handle switch Contact an authorized APEC Distributor.
Eliminate extension cord & locate a power source closer to work site.
Have voltage checked by a qualified electrican.
Not on a dedicated circuit Make sure there is no other items using power on the circuit.
Try a different driver/head that is less aggressive.
DO NOT add weight to machine. Remove any excess weight added to machine.
Bad connection Contact an authorized APEC Distributor.
Defective motor Contact an authorized APEC Distributor.
Defective pad One side is more dense than the other. Replace pad.
Machine left setting on pad for extended time Pad has taken "a set". Replace pad.
Warped block on brush or padholder Replace.
Block not installed properly Remove and install properly.
No powerNo power
Low voltage
Low voltage
Machine wobbles during
operation
Machine will not start
Motor runs sluggish
Fuse / circuit breaker
repeatedly trips
Motor is overloaded
Scheduled Maintenance
Daily Weekly Monthly
Every 6
Months
Annually
Empty the water tank

Remove driver / pad holder

Check for loose or lost fasteners

Inspect hoses and connections

Inspect driver / pad holder for damage

Clean the machine and accessories

Test the GFCI

Check the power cord for damage

Check machine wiring for fray or cut

Interval
These items must be performed with the proper tools and training. Contact an Amano Pioneer Eclipse
Factory Certified Technician unless you have the proper equipment and mechanical proficiency.
Operation