Need help?Do you have a question about the Amantii TRU-VIEW-XL and is the answer not in the manual?
General| Model | TRU-VIEW-XL |
|---|---|
| Category | Indoor Fireplace |
| Type | Electric |
| Style | Modern |
| Depth | 12 inches |
| Volts | 120V |
| Watts | 1500W |
| Flame Effect | Yes |
| Flame Colors | Multi-Color |
| Remote Control | Yes |
| Wall Mountable | Yes |
| Built-in Recessed | Yes |
| Heating Capacity | 400 sq ft |
| Amps | 15A |
| Power Consumption | 1500W |
Remove front glass and internal bars to access and replace the ember bed LED light.
Remove side and visual glass panels to access and replace the flame effect LED.
Disconnect the flicker rod from the motor for the ember bed effect.
Disconnect the flicker rod from the motor for the flame effect.
Unscrew screws and pull down the heating element set for removal.
Unscrew mounting screws to separate the heater from the heating element set.
Remove the control board by unscrewing mounting screws to access the PCB.
Disconnect and install the new PCB board for the fireplace.
Locate and unscrew the signal receiver unit for replacement.
Unplug the signal receiver connector from the main PCB board.
Unscrew side fasteners to carefully remove the front glass panel.
Unscrew canopy screws and unplug the cable to replace the top light.
To Next Page
