Amantii SYM-34 - User Manual

Other manuals for Amantii SYM-34

Installation And Operation Instruction Manual29 pages

Installation And Operation Instructions36 pages

Assembly, Installation And Operation Instructions35 pages

Questions and Answers

R
Robin TurnerAug 7, 2025
What to do if Amantii SYM-34 turns off and won't turn on?
- L
  laurie13Aug 7, 2025
  If your Amantii Indoor Fireplace turns off and won't turn back on, it could be due to several reasons. First, the appliance may have overheated, causing the thermal switch to disconnect. To resolve this, turn off the main switch and allow the appliance to cool down for 10 minutes before turning it back on. Second, the house circuit breaker might have tripped; in this case, reset the house circuit breaker. Finally, the appliance's fuse may have blown, requiring you to replace the fuse.
S
Stephen McdowellAug 11, 2025
Why Amantii SYM-34 Indoor Fireplace will not come on?
- A
  Anthony ClarkAug 11, 2025
  If your Amantii Indoor Fireplace does not turn on when you flip the switch to the ON position, there are a few potential causes. First, ensure that the appliance is properly plugged into an electrical outlet. If it is, the appliance may have overheated, causing the safety device to disconnect the thermal switch. To fix this, turn off the main switch, let the appliance cool down for 10 minutes, and then turn it back on. Alternatively, the circuit board might be burnt out, requiring inspection and replacement if necessary.
R
Robert MartinezAug 16, 2025
How to fix Amantii Indoor Fireplace remote control?
- A
  Amber RobinsonAug 16, 2025
  If the remote control for your Amantii Indoor Fireplace isn't working, the batteries might be low. Try replacing the AAA batteries in the remote control. Also, ensure that the unit switch is in the “I” position.
N
Nathan PattersonAug 20, 2025
Why Amantii SYM-34 Indoor Fireplace has dim flame?
- A
  Amanda MoralesAug 20, 2025
  If your Amantii Indoor Fireplace has a dim or no flame, it could be because the flame LEDs are burnt out. Inspect the LEDs and replace them if needed. Another possible cause is that the back black cloth is falling off and rolling the flicker. In this case, change to a new flicker and back black cloth.
J
Jillian SmithAug 25, 2025
Why Amantii SYM-34 Indoor Fireplace has no warm air?
- W
  Walter OliverAug 25, 2025
  If no warm air is coming out of your Amantii Indoor Fireplace, the heater might be burnt out. Inspect the burner and heater assembly, and replace it if necessary.
J
John PerryAug 28, 2025
What to do if Amantii SYM-34 Indoor Fireplace ember bed is not glowing?
- M
  mariadeleonAug 28, 2025
  If the ember bed in your Amantii Indoor Fireplace is not glowing or is dimming, the ember LEDs might be burnt out. Inspect the ember bed LEDs and replace them if necessary.
L
Laurie BennettSep 1, 2025
Why Amantii SYM-34 flame sputters?
- O
  Olivia AlvarezSep 1, 2025
  If the flame sputters in your Amantii Indoor Fireplace, the flame motor may be defective. Call a qualified service technician to replace the flame motor.

Amantii SYM-34 Specifications

General

Model	SYM-34
Type	Electric Fireplace
Width	34 inches
Voltage	120V
Wattage	1500W
Rated Voltage	120V
Rated Frequency	60Hz
Rated Current	12.5A
Heater Wattage	1500W
Heating Capacity	5000 BTU
Flame Effect	Yes
Flame Color Options	Multi-Color
Remote Control	Yes
Thermostat	Yes
Timer	Yes
Finish	Black
Installation	Wall-mounted