16
EN
Changing Batteries
WARNING
Risk of electric shock!
Disconnect the product from any circuit, remove
the connector leads (Q) from the input jacks (F)/(G)/
(K)/(L), and turn OFF the product before opening
the battery compartment (O). Do not operate the
product with an open battery compartment.
NOTICE
Replace the battery when the low
battery indicator (4) is shown on the display (A).
• Open the tilt stand (N).
• Loosen the screw of the battery compartment
cover (O) and remove it.
• Insert a 9 V(6F22) battery and attach it to the
snap connector.
• Place the battery in the battery
compartment(O) and close it.
• Close battery compartment (O) and tighten the
screw.
To Next Page
