7
• This appliance is classified as protection class I and shall be connected to a MAINS socket outlet
with a protective earthing connection.
• Regularly check the power plug and power cord for damage. If the supply cord is damaged, the
adapter cannot be used and needs to be replaced.
• Avoid damage to the power cord. Do not crush, squeeze, bend, or scour on sharp edges.
Keep the power cord away from hot surfaces and naked flames.
• Do not defeat the safety purposes of the polarized or grounding-type plug. Polarized blades
with one blade wider than the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong is provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
• Lay the cables in such a way that nobody can inadvertently pull them or trip over them.
• Do not pull the plug out of the socket by the power cord, and do not wrap the power cord
around the appliance.
• If an extension cord is used, its capacity needs to be suitable for the power consumed by the
appliance.
•
Connect the power adapter to an easily reachable electrical outlet so that the appliance can be
unplugged immediately in case of an emergency. Pull the power adapter out of the electrical
outlet to completely switch off the appliance. Use the power adapter as the disconnection device.
• Disconnect the power adapter from the electrical outlet when not in use and before cleaning.
• Unplug this product during lightning storms or when unused for long periods of time.
• Always switch the appliance off before disconnecting the power adapter.
• Only use this product with the supplied power adapter.
• Attention! In the event of a malfunction as a result of electrostatic discharge and momentary
electrical surges, unplug the appliance and plug it in again.
•
Make sure that no electrical wires, water, gas or other lines are located around the installation location.
• Ensure that there is sufficient ventilation. Keep a minimum distance of 4 inches (10 cm) between
the appliance and other objects or walls.
This symbol indicates the compliance with Canadian and USA safety requirements.
For indoor use only.
This symbol indicates the compliance with energy efficiency requirements.
To Next Page
Loading...
Need help?
General