33
Troubleshooting
When the following occur, the cooker is not defective, please carefully check once before sending
it in for repair.
S/N
Problem Reason Solution
1 Difficult to close the lid
Sealing ring not installed
properly
Position the sealing ring
well
The float valve clamps the
push rod
Lightly push the push rod
2 Difficult to open the lid
Float valve in the popped-
up position
Press the float valve lightly
with a chopstick.
Pressure exists inside the
cooker
Open the lid after the
pressure is completely
released.
3 Steam leaks from the lid
Sealing ring installed
improperly
Install the sealing ring as
required
Food debris attached to
the sealing ring
Clean the sealing ring
Sealing ring damaged Replace the sealing ring
The lid is not closed
correctly
Close the lid correctly
4
Steam leaks from the float
valve
Food debris on the float
valve gasket
Clean the float valve gasket
Float valve gasket worn-
out
Replace the float valve
gasket
5 Float valve unable to rise
Too little food and water in
inner pot
Add water and food
according to the recipe
Steam leaks from the lid or
exhaust valve
Send to the service center
for repair
6
Steam comes out from the
exhaust valve non-stop
Exhaust valve not in the
sealing position
Turn the exhaust valve to
the sealing position
Pressure control fails
Send to the service center
for repair
7
Power indicator does not
go on
Power socket poor contact
Please check the power
socket
To Next Page
Loading...