8 ENGLISH
Operation
Paper / Credit Card Entry:
Make sure you do not exceed sheet
count per pass (12 sheets max).
Insert paper as straight as possible
into feed slot and release.
Insert one credit card at a time into
the middle of the feed slot.
Note:
•Always turn off and unplug the shredder when not in use.
•This shredder will shred staples and small paper clips. It is recommended that you remove
paper clips whenever possible to extend the lifespan of your shredder.
•Only shred credit cards by feeding them vertically i nto the middle of the feed slot, releasing
when shredding begins. Never feed more than one credit card at a time.
LED Status
Indicators:
Misaligned / Overload
Overheat / Power On
•Power On: The Green LED light indicates the shredder is “On” and ready to operate when
paper is inserted.
•Overheat:The Red LED light indicates the shredder has shred continuously beyond the
maximum run time and overheated, the unit will automatically shut off. If this happens, switch the
shredder Off for 30 minutes or longer before resuming normal operation.
•Overload:The Red LED light indicates when too much paper is inserted. Use the "Reverse"
mode to back up and reduce number of sheets.
•Misaligned: Mount the shredder securely to the rim of the waste basket.
To Next Page
Loading...
Need help?
General
