AmazonBasics B07NDJTS6S

14
Problem Solution
The shredder is
constantly running
while in “Auto (On)”
mode.
• It is possible that the activation sensor, which starts the shredder, has
become blocked with paper. Insert an index card or any rigid sheet
of card stock (old greeting card or folded file folder) directly into the
center of the feed slot while applying force to help push the jammed
paper through. This will usually clear any paper blocking the activation
sensor and feed slot.
• The activation sensor is being triggered by dust, debris, or oil. A
cotton swab may be used to clean the sensor. Do not use canned air.
The activation sensor of the shredder is located around the center of
the feed slot.
Specifications
Sheet capacity: 8Sheets of 20lb bond paper*
Paper shred size:
5/32in x 15/32in pieces
4mm x 12mm pieces
Paper feed slot width: 8.7in (22.0cm)
Credit card & CD capacity: 1 at a time
Duty cycle: 5min on / 30min off
Voltage: 120V~, 60Hz / 3.5A
Shreds credit cards, small paper clips, staples and CDs/DVDs.
* One Folded Sheet Of Paper Equals 2Sheets Of Paper
Heavier paper, humidity or other than rated voltage may reduce shredding capacity.