8
Operation
3
1
2
8
8
8
8
8
8
1. Control switch
Using the switch located on the unit, select one of the following settings by sliding the switch either
left or right.
Auto / On: This setting allows the shredder to be automatically started by inserting
paper into the feed slot. Always feed the paper in as straight as possible. When the
paper has passed through, the shredder will automatically stop.
Off: This setting turns off all features of the shredder. For safety reasons, we
recommend that you leave the shredder in the “Off” position whenever the shredder is
unattended or not in use.
Reverse: In the unlikely event of a paper jam, the reverse setting can be used to help
clear the cutters of paper that did not pass through. Never attempt to clear a jam by
using the reverse function until you have emptied the wastebasket.
Forward: The forward setting can also be used to help clear the cutters in the event of
a paper jam. This allows you to manually activate the shredder to cutting mode.
To Next Page
Loading...
Need help?
General
