19
EN
– Alternatively, you can set the concerned timer to 0.0 h.
Sleep function
NOTICE
The sleep function works only when the product is set to
cooling or auto mode.
– The sleep function increases the target temperature by 2 °F (1 °C) 30
minutes after activation.
– After another 30 minutes the target temperature is increased by
another 2 °F (1 °C).
– The product maintains the temperature for the following 6
hours. Afterwards, the product returns to the originally selected
temperature.
• Press the sleep button (14) to activate the sleep function. The
activated sleep function is being indicated with a light above the
sleep button (14) and with a on the remote control display (X).
Energy saver
NOTICE
The energy saver control does not work in fan mode.
– While the energy saver is activated, the product is cooling the room
with the maximum compressor efficiency below the set target
temperature.
– When the room temperature is below the set temperature, the
compressor switches off. Only the fan is working in short intervals.
– When the room temperature increases above the set target
temperature, the compressor switches on again.
• Press the energy saver button (8) to activate the energy saver.
The activated energy saver is being indicated with a light above the
energy saver button (8).
Follow me function
• Press the follow me button (20) to activate this function.
• While activated:
– The follow me indicator (9) lights up and is shown on the left
side of the remote control display (X).
– The remote control displays the temperature of its immediate
surroundings.
To Next Page
Loading...
Need help?
General
