1. Plug small end of the USB charging cable into micro USB jack at back of the speaker.
2. Plug the other end of the USB charging cable into an available USB port on your computer or an USB power adaptor on wall.
3. Red LED at back of the speaker is on during charging. When fully charged, the LED will go off.
Note:
When battery is low, the speaker will have a warning tone and the red LED will flash slowly.
1. Slide the switch on back of the speaker to “on” position. Blue LED at front of the speaker flashes fast.
2. Navigate to your device’s Bluetooth settings, turn on Bluetooth, and then search for available devices.
3. Select Paring Name from a list of available devices on your Bluetooth device. The Blue LED turns solid when your device is
4. Choose the music on your device to play through the speaker.
5. Adjust speaker volume through the and the buttons on top of the speaker.
6. To disconnect from the paired Bluetooth device, turn off Bluetooth on your device or long press the button until Blue
LED flashes fast with a prompt tone.
Note:
1) The maximum Bluetooth range is 33 feet.
2) Make sure the volume level on your Bluetooth device is at least 50%.
3) When speaker is turned on, it will try to connect the last paired Bluetooth device automatically within 10s. If the last paired
Bluetooth device is out of range, it will automatically search for another device for pairing.
When paired to your mobile phone:
1. With a coming call, short press the button to answer it. Double click the button to reject the call.
2. Press the or the button to increase or decrease the speakerphone volume.
3. Short press the button again to end the phone call.
Note: For Android users, make sure that the “Phone Audio” function is active in the Bluetooth settings.
Operation Instructions
Step 1:
Charging the speaker
Step 2:
Play music through Bluetooth
Step 3:
Using the Speakerphone
Step 4:
Play music through AUX
To Next Page
Loading...
Need help?
General
