Need help?Do you have a question about the Amazone ZA-X 603 and is the answer not in the manual?
Defines DANGER, WARNING, CAUTION, IMPORTANT, and NOTE signal words and their significance.
Specifies required training for personnel operating, maintaining, or repairing the machine.
Details the structure and meaning of warning pictograms used on the machine.
Critical safety instructions for working with the high-pressure hydraulic system and hose lines.
Safety procedures for electrical systems and proper operation of the PTO shaft.
Defines the machine's intended agricultural applications, mounting, and terrain limitations.
Provides detailed technical data for various models including capacity, weight, dimensions, and drive specifications.
Lists necessary tractor specifications and provides noise production data for the machine.
Provides tables for setting spread rates based on working width, speed, and fertiliser type.
Guides on using the setting chart and accessing AMAZONE's Fertiliser Service for recommendations.
Details checks for tractor compatibility, including weight, axle loads, and minimum ballast calculation.
Provides formulas and steps for calculating minimum front ballast, axle loads, and total weights.
Summarizes calculated values against approved tractor values and outlines safety warnings for non-compliance.
Instructions for correctly adjusting PTO shaft length to prevent damage and ensure safety, referencing manufacturer guidelines.
Critical safety procedures to secure the tractor and machine against unintentional starting or rolling during work.
Step-by-step guide and safety warnings for connecting the machine to the tractor, including link pin checks.
Procedures and safety precautions for safely disconnecting the machine from the tractor.
Guides on adjusting the slider position using the setting lever based on charts or calibration kit.
Instructions on how to use the setting chart to determine the correct slider position for desired spread rates.
Describes how to adjust the working width by swivelling spreading vanes based on fertiliser type and desired width.
Detailed guide on adjusting spreading vane positions using scales for precise spread pattern control.
Instructions and safety precautions for filling the hopper, including checking for debris and payload limits.
Details the spreading operation, wear parts, and critical safety warnings related to moving parts and ejected objects.
Method for performing a spread rate check while the machine is stationary, including example calculations and time conversion table.
Lists common faults, their causes, and recommended remedies for the fertiliser spreader.
Provides a schedule for daily, weekly, and as-needed maintenance tasks with references to specific pages.
Critical safety and maintenance procedures for the hydraulic system, including hose lines and fluid handling.
To Next Page
General