Need help?Do you have a question about the Amazone E+S and is the answer not in the manual?
Specifies the intended uses of the AMAZONE E+S spreader for winter service.
Details manufacturer info, conformity declaration, and after-sales service procedures.
Information on the machine's type plate for identification and ordering parts.
Lists operational parameters, PTO speed, hydraulic pressure, and connection requirements.
Reports the measured emission sound pressure level at the tractor operator's ear.
Explains the meaning of general danger, attention, and hint symbols used in the manual.
Defines operator requirements and risks associated with ignoring safety advice.
Covers front axle load reduction and keeping agitator clean and operational.
Explains the CE sign and the importance of referring to the operator's manual.
Details hazards from rotating shafts, spreading discs, and flung material particles.
Covers general safety, decals, traffic rules, machine controls, and clothing.
Advice on implement mounting, operator seat, vehicle loads, and road travel.
Safety advice for mounting, dismounting, and transporting implements on the three-point linkage.
Safety guidelines for PTO shafts, including guards, and hydraulic system operation.
Safety rules for maintenance, repair, and cleaning, including power disconnect and fluid handling.
Steps for cleaning the spreader after use, including dismantling the bottom group.
Lists the main components of the spreader and its standard equipment.
Details the drive options: PTO shaft or hydraulic motor.
Explains material movement from hopper to disc via agitator and vanes.
Describes how to adjust working width and set the spread rate using the shutter.
Instructions for checking the spreader for transit damage and performing a basic function test.
Details the PTO shaft drive mechanism for the spreading disc and agitator.
Step-by-step instructions for safely attaching the PTO shaft.
Instructions for mounting the spreader to the tractor's three-point linkage.
Specific steps for attaching the PTO shaft and ensuring guard safety.
Procedure for connecting hydraulic hoses for models with a hydraulic motor.
Steps for safely removing the spreader from the towing vehicle.
Adherence to national traffic laws, lighting, and warning requirements for road transport.
Covers PTO shaft angling, drive engagement, and safe filling procedures.
Instructions for setting the spreader's mounting height relative to the ground.
Procedure for setting the working width and verifying its accuracy.
Method to measure and calculate the actual operational speed of the towing vehicle.
Formulae for calculating the required spread rate per minute based on desired settings.
Safety rules for maintenance, repair, and cleaning, including power disconnect and fluid handling.
Steps for cleaning the spreader after use, including dismantling the bottom group.
Instructions for removing and cleaning the bottom group of the spreader.
Information on lubrication intervals for the PTO shaft.
Details on checking gearbox oil level, refilling, and maintenance intervals.
Information about spare shear bolts for the PTO shaft yoke and greasing.
Table provides recommended shutter positions for spreading sand at various speeds and widths.
To Next Page
General