34
Cleaning, maintenance and repair
DB 534 02. 02
8. Cleaning, maintenance and repair
a
As a matter of principle all repair-,
maintenance- and cleaning work as well
as remedy of function faults should be
carried out with disengaged universal
joint shaft and stopped vehicle engine.
Remove ignition key.
a
When doing maintenance work on the
lifted implement make sure that it is
secured by proper supports.
a
After disengaging the pto shaft the
mounted implement may still continue to
run by it’s dynamic masses. Begin to
work only when the implement has come
to a full standstill.
a
Any spare parts fitted must, as a
minimum meet with the implement
manufacturers' fixed technical
standards. Using original AMAZONE
spare parts for example ensures this.
a
All hydraulic hoses must be checked for
their operational safety in regular
intervals. Exchange in case of damage
or ageing. The period of use of any hose
circuit should not exceed six years. The
replacement hoses must correspond to
the technical demands of the implement
manufacturer.
a
When searching for leaks appropriate
aids should be used because of the
danger of injury.
a
Liquids leaking under high pressure
(hydraulic oil) can penetrate the skin and
cause severe injury. When injured see a
doctor immediately! Danger of infection.
a
Before starting to do repair work to the
hydraulic system, lower machine to the
ground, release the pressure and stop
vehicle engine.
a
Dispose of oil, grese and filters in the
appropriate manner.
a
Grease the shutter guides after any
operation.
a
In case of injuries caused by penetrating
oil consult a doctor immediately.
8.1 Cleaning
After use clean the machine with a normal jet of water
(greased implements only on washing bays with
oil traps).
Dismantle bottom group and clean carefully.
Treat dry machine with an anticorrosive agent(Only
use biologically degradable protective agents).
Park machine with opened, greased shutter.
To Next Page
Loading...
