26
Mounting and dismounting
DB 534 02. 02
5.3 Initial fitting and matching up
of the PTO shaft
When initially fitting, match PTO shaft to the vehicle.
As this matching only applies for this specific vehicle
type, check or repeat PTO shaft matching when
changing vehicles.
I
Observe the instruction manual of the
PTO shaft manufacturer.
- Pull apart the PTO shaft halves.
- Fit PTO shaft half to the vehicle side.
- Hold the PTO shaft halves (1) and (2) in their
shortest and longest operational position side by
side and check the overlap of the PTO shaft
tubes.
-In shortest position the universal joint shaft
tubes must never hit the universal yokes. Allow a
safety spacing of at least 40 mm.
- In the longest operational position the PTO
shaft tube overlapping prescribed by the PTO
shaft manufacturer has to be observed (please
refer to the instruction manual of the PTO shaft
manufacturer).
- For matching the length of the PTO shaft halves
hold them side by side in the closest operational
position, mark and shorten according to
indication of the PTO shaft manufacturer.
- Insert PTO shaft halves into one another.
- Push PTO shaft on the vehicle’s universal joint
shaft.
a
Ensure a proper catching of the PTO
shaft connection.
- Hook in fixing chains of the PTO shaft guard on
towing vehicle and implement side so that a
sufficient swivel range of the PTO shaft in all
operating positions is ensured and that the PTO
shaft guard does not spin during operation.
a
On towing vehicle and implement only
use PTO shaft with complete guard and
additional guard fitted. Replace guards
immediately once they have been
damaged.
To Next Page
Loading...
